RADAR Level Transmitter for Non-Contact Metal Tank Level Measurement

RADAR level transmitters allow simple and reliable non-contact level measurement of fluids in a metal tank. The microprocessor-controlled electronics transmit a 6.3 GHz electromagnetic pulse at the fluid's surface, which is then reflected back to the antenna. The "round trip" time of flight is then calculated to determine the fluid level in the container.

Pulsed RADAR can "see through" environments that would normally interfere with an ultrasonic type sensor, thus fuming and foams can be ignored in the field.

Our proprietary software senses and analyzes the amplitude and shape of the received echos. This enables the units automatic gain control to track the process level and also elimnate false echoes from unwanted obstructors such as standpipes or tank walls.

The dielectric constant of a material is important to the proper operation of RADAR units. Each unit has the ability to work with materials that have a dielectric constant greater then 2.
RADAR Level Transmitter for Non-Contact Metal Tank Level Measurement

A single push-button is used to set the zero and span. Callibration can be done in the vessel by varying the fluid level, or the unit can be calibrated on the bench by aiming the unit at a suitable target. Factory pre-calibrated units are available.

With the optional communication software, the unit can be programmed with any personal computer. This software also enables diagnostics, data logging and special calibration, such as configuring the unit to work in a narrow pipe.

The zero and span points are independent of each other and fully adjustable over the units range.

RADAR Level Transmitter for Non-Contact Metal Tank Level Measurement: Ordering Information

RADAR Level Transmitter for Non-Contact Metal Tank Level Measurement: Calibration

PDF Brochure - This is a large file and download speeds vary.

Electrical:	Power (+/- 20%)	115VAC/60Hz 230VAC/50Hz (Optional) DC: 12 to 30 VDC
	Output	4-20mA or 20-4mA 6.1uA resolution 750 ohms (Isolated on AC units)
	Fuse	0.125A/250V type 2AG
Mechanical:	Process Entry	2" NPT Standard
	Conduit Entry	1/2" NPT
	Antenna	Polypropylene (Standard) Teflon (Optional)
	Enclosure	Aluminum (Standard) Stainless Steel (Optional) NEMA 4 (IP65)
Environmental:	Temperature	Electronics: -40F to 140F PP Antenna: -40F to 190F Teflon Ant: -40F to 250F
	Pressure	150 PSIG Max.
	Approvals	FCC Part 15 - Low Power Communication Device
Operational:	Range:	50 or 100 feet - mode dependent
	Accuracy	+/- 0.25% of maximum target range in air
	Frequency	6.3 GHz
	Transmitter Power	50uW average
	Loss Echo	30 sec. hold time, then 22mA output

Specifications are subject to change without notice.

We invite you to contact us with your next application.